Mud-club

Vehicle & Technical => Suzuki => Topic started by: fuddy-mukker on March 15, 2008, 21:36:15

Title: vit to sammi axle
Post by: fuddy-mukker on March 15, 2008, 21:36:15

Could anyone help with this question please,

i will be fitting a sammi axle to my vit and was wondering if i needed to get sammi callipers to fit or would the vit ones bolt straight to the sammi axle. also how would i stop the prop shaft from pulling out of the transfer box every time i go over rough ground, do i need to replace the vits t box with a sammi one ??

Cheers,

Chris.

Title: Re: vit to sammi axle
Post by: markyb on March 17, 2008, 10:44:41

vit calipers fit, you might as well use the disks. your need to fit the vit caliper brackets to the sammy axle.

i drilled my vitara t case and tapped it but your need a lot of patience and a best quaity drill bits to get through the hardened shaft.

i did think after all that that it might not be needed if you guage the movement on the prop as you do have a fair amount of movement on the yoke that goes into the t case.

sj box howerver would give you lower gears.