Mud-club
Chat & Social => The Bar - General Chat => Topic started by: Matt_H on February 06, 2005, 14:45:24
-
Anyone got one I could borrow for five mins? * I've just snapped a brake pipe
*and a couple of feet of brake pipe
ta
Matthew
-
just been out to the shed to check its there and i've also got a roll of brake pipe
Give me a ring if you need it 07747695567
Steve
-
You be carefull Matthew, [-X but I tip my hat to you for doing the work. =D>
-
Got one but not a lot of good in Nottingham.
Ed
-
got one made up and a mates place. And thanks for the offer Steve - much apperciated!
Will have to buy myself one asit's something that you use rarely but when you need one, nothing else will do!
Matthew
-
Kev Hobbit came round here with a joint that he wanted to replace. It looked like someone made it with a ball pein hammer...
No wonder it leaked.
Ed
-
I've just bought one on ebay for £15 inc postage, so probably a fiver off compared to my local motor factor... it's a sealey one so quality should be 'ok'
Right need to buy some pipe and some nut thingies that go on the end... only problem is I've no idea if they are metric or imperial.. Anyone know, 1990 2.5 tdi disco non abs model.
Ta
Matthew
-
My 93 (200) is 10mm 1mm pitch and short. I had to use long as I'd run out and it doesn't make much difference bar the amount of thread left.
Ed
-
lovely jublly! ta.. I used long ones on my emergency pipe I made up today and as you say only really affects amount of thread sticking out (didnt know that before today though!)
I'll buy a bag of metric ones I've seen on ebay then
Matthew