Mud-club
Vehicle & Technical => Series Land Rovers => Topic started by: Panda on April 19, 2008, 01:52:55
-
Ok now my truck has its new look i cant keep the old rear tub cover. so i have a sheet of check plate and i have a few ideas but not sure which one to go for, so my questions are, which one would you choose, why would you choose that and can you see any problems with any of them?
Below are my four ideas the designs are a little red neck but best i could do with what i got. Any and all help would be grate.
(http://i305.photobucket.com/albums/nn231/Pandalr88/untitled.jpg?t=1208565858)
(http://i305.photobucket.com/albums/nn231/Pandalr88/untitled2.jpg?t=1208565891)
(http://i305.photobucket.com/albums/nn231/Pandalr88/untitled3.jpg?t=1208565924)
(http://i305.photobucket.com/albums/nn231/Pandalr88/untitled4.jpg?t=1208565951)
Thanks
-
Hello,
Its hard to say which would be best and it is likley to depend on what you use the beast for and what you carry. Option 1 looks most secure so if its tools and recovery gear it may be a winner, but also less flexable (in both senses of thde word)
My advice is to build a prototype in plywood. as you will cut it quicker and save wasting your chequreplate.
You can try out any/all designs and it will also show you if you have unforseen clearance problems or issues with where to fix/support the top.
Yo may find that you ave a problem with rigidity.
Alos beware that hinges dont allways offer tue 180deg folding, especiallly once fixed to a surface. For example if the hinge is on the inside of the lid, when you fold it open the chequre plare will prevent it folding flat so this may influence how you use (and design) the thing.
Good luck, measure twice, cut once etc....
-
I like idea 1, simpler than the others and maybe easier to make secure, does this have to be water-proof too? as that'd be the hardest thing to get around if it is! could you bolt spare wheel down on idea 1 and when open it would go between roll cage rear bars? or is there not enough length?
-
does this have to be water-proof too?
No it doesn't have to be water tight but i would like it water resistance and to make it like that i was thing that i could run a bead of silicon around the edge and hope for the best.
could you bolt spare wheel down on idea 1
I have just got a swing away spare wheel carrier. so that's not an issues.
when open it would go between roll cage rear bars? or is there not enough length?
If i was to go for idea one then yes the metal would hit the roll cage bars and have to rest on them only giving me access to have of the tub.
Thank you Mr carbore and Mr lightweight :clap: you have some good ideas that i didn't even thing about :doh:
-
I'd go for no 2 then fit some of those bonnet strut thingys to keep the lids in an upright position allowing you to put something big and bulky in the back if the need ever arises