Mud-club
Vehicle & Technical => Discovery => Topic started by: bambamjj on May 25, 2008, 16:53:28
-
Hi
Just purchased original landrover front fog light switch to enable me to wire in front spotlights as the original was a large plastic toggle switch with 3 pins screwed in to dash.
Does anyone know what the wiring is for this switch, it has 5 pins i need to know the following, earth, power in & power out (to spots) it has been wired in previously so that the power in comes from the activation of the main beam.
-
id forgot using land rover wiring looms just use a ring wiring kit for a tenner and save future problem.
-
its not the loom im using just want to use the switch so all fits in nicely with the dash
-
1 will be earth, 1 power in, 1 power out, 1 illumination, 1 unused iirc
-
thanks :D, But
what number will be earth
what number will be volt in
what number will be volt out
what number will be illumination
-
I think it works like this
Pin
5 - earth
4 - Power Out
3 - unused
2 - illumination
1 - Power in
BUT I've not tried it yet so you will need to test it.
-
I think it works like this
Pin
5 - earth
4 - Power Out
3 - unused
2 - illumination
1 - Power in
BUT I've not tried it yet so you will need to test it.
That's what RAVE says it is ... so it's probably wrong :dance:
-
I think it works like this
Pin
5 - earth
4 - Power Out
3 - unused
2 - illumination
1 - Power in
BUT I've not tried it yet so you will need to test it.
I couldn't find it on rave :doh: I trawled the net and played with my metre :shock:
That's what RAVE says it is ... so it's probably wrong :dance:
-
I couldn't find it on rave :doh: I trawled the net and played with my metre :shock:
Now that's just boasting :-#
-
I couldn't find it on rave :doh: I trawled the net and played with my metre :shock:
Now that's just boasting :-#
:clap: :clap: :clap: :clap: :clap: :clap: :clap: :clap: :clap: