Mud-club

Chat & Social => The Bar - General Chat => Topic started by: bambamjj on July 15, 2008, 13:27:34

Title: rear recovery points
Post by: bambamjj on July 15, 2008, 13:27:34

hi all

The towbar on my Disco 1 was shot so took, or should i say cut it off but now i cannot use the chassis points to put jate rings on as they are solid with the remains of the bolts from the towbar, tried drilling but that just blunts them.

Any alternative suggestions? Heating has not worked either, was thinking off cutting the Tubular section out and leave the vertical plates with holes on but will i have to get some new tubular section?

Dont want to off road untill i have decent recover points, fronts Ok but just stumped by rear end.

Title: Re: rear recovery points
Post by: robert francis on July 15, 2008, 19:11:35

have you tried a punch and hitting the poo out of it with a club hammer, or just get loads of dril bits a just keep going,

Title: Re: rear recovery points
Post by: bambamjj on July 15, 2008, 19:34:36

Tried punch lump hammer just about everything including G clamp tightened with extension bar, still no go

Title: Re: rear recovery points
Post by: carbore on July 15, 2008, 19:54:20

Drill in and fix/weldsome swivel eyes elsewhere on the bumper?  not sure as never done it but if the tow ball was a mess then make sure the rest of the bumper isnt as well or it will only the bumper that get pulled out of the mud!

Title: Re: rear recovery points
Post by: lambert on July 15, 2008, 19:56:48

Tried a gas axe? Used sparingly of course.