Mud-club

Vehicle & Technical => Discovery => Topic started by: Disco-Ron on August 09, 2008, 16:19:02

Title: Rear diff drive flange removal.... 300tdi!!
Post by: Disco-Ron on August 09, 2008, 16:19:02

HI all, i'm changing the rear prop to one without that stupid rubber flange, i've got to the point of removing the drive spider, but there's no nut visible, there's a round bar that was in the rubber thing, how do i get that out of the flange, to access the nut..???

All help very much appreciated, as the truck is in bits and immoblie...

Thanks!!

Title: Re: Rear diff drive flange removal.... 300tdi!!
Post by: Gav_T on August 09, 2008, 16:43:59

In the centre it is threaded. I used some threaded bar, bit of pipe larger than the bit that went into the rubber donut and some big washers. The pipe/tube goes over the locater (really dont know what its called!) in with the threaded bar, slide on the big washers (bigger than the tube) and put a nut on. Just keep tightening it up and it will pull it out.

This is what i did with mine as far as i can remember!

Also i used the old part to cut down to use as a shim for the 200 series flange.

HTH

Gavin.

Title: Re: Rear diff drive flange removal.... 300tdi!!
Post by: karlo on August 09, 2008, 21:11:37

Ashcrofts also do the spacer


part no
539745----£4.00
Carriage---£2.00
VAT-------£1.05
______________
Total------£7.05
______________

Title: Re: Rear diff drive flange removal.... 300tdi!!
Post by: Disco-Ron on August 09, 2008, 23:51:09

Well i got it off.... with a grinder..!!!

I got the new flange from QT, along with a wide angle prop, it fitted spot on with no spacer etc, once i'd got the new seal set in correctly!!