Mud-club

Chat & Social => The Bar - General Chat => Topic started by: lee celtic on September 17, 2008, 20:35:35

Title: Hi Lift rebuild
Post by: lee celtic on September 17, 2008, 20:35:35

Hi Guys and girls.

I have bought an old hi lift and stripped , blasted and painted it .

as I was doing this I made a note of where everything went however I didn't make a note of which way up the climber pins go :oops:

so the question is does the bevel face up or down or each other or away from each other  :roll: :oops: :lol:

Title: Re: Hi Lift rebuild
Post by: Range Rover Blues on September 17, 2008, 23:35:36

Both face ther same way, such that the saddle can ride up the rack, or you can pull it up by hand.

Title: Re: Hi Lift rebuild
Post by: lee celtic on September 18, 2008, 18:03:09

Thanks RRB :D

so both bevels facing up then  :lol:

thats the way I put it together but I wanted to check  ;)

both pins had marks on the none bevel side that looked like they had some weight on them at some point this was the only clue I had :D

Title: Re: Hi Lift rebuild
Post by: Range Rover Blues on September 21, 2008, 02:07:45

Check it works though before you need it :-.

Title: Re: Hi Lift rebuild
Post by: lee celtic on September 21, 2008, 16:12:41

Have done works fine if a little sticky (new paint) more lube me thinks  ;)