Mud-club
Vehicle & Technical => Discovery => Topic started by: auf_wiedersehen_pet on November 15, 2008, 19:12:51
-
If my 95 Disco was wired for elec seats, where would the connection for the ECU be?
-
I have a set of electric seats from a later disco to fit in my 1995 300TDI. I was fortunate enough to remove these from the newer disco, and all the looms seemed to originate from the center console, with 4 relays located under the passenger seat.
I have yet to find any spare connectors in my Disco for either the seat wiring, or the switch wiring in the console. i have had the carpets up, and looked as best i can in the console, without yet taking it out.
Hope this helps :?
-
Does that mean they aren't "plug & play"?
Did you wire them by adding a 12v supply to switches? Or did it take more?
-
Does that mean they aren't "plug & play"?
Did you wire them by adding a 12v supply to switches? Or did it take more?
well the short answer is, they are still sitting in the garage. This is due to the fact that i need to make adapter plates up for them to fit the existing seat mounts. I have connected the wiring to a 12v battery and all works through the switches, so my plan is to connect an existing supply or run a new supply. Not sure yet if i am going to use the relays, as they will just be another item i need to find somewhere to put?
I got the seats as my drivers seat base went. the cloth bit that supports it at\ the bottom has had it. I managed to bodge a repair with some straps, that has held now for 4 months, so i must admit, i am not sure if its worth the hastle fitting the leather ones? Back one went straight in and is nice though lol