Mud-club
Vehicle & Technical => Discovery => Topic started by: Disco Matt on November 24, 2008, 15:20:06
-
On Wednesday I intend to have a go at fitting my new tree sliders, but I was wondering if anyone has any useful hints/tips/advice? They're the Guardian ones. I have held them against the car and it appears that the rear of the two bolts that go through the sills (the one nearest the B pillar) uses one of the holes that the original plastic trim was attached to in order to locate the slider before drilling the other holes - is this right?
Planning to use a couple of scissor jacks to support the sliders while I work, as those will enable me to adjust them by fractions of a millimetre to get them straight and level.
-
Ive fitted them onto my disco, and my advice is drill and bolt the sill first, so that when you come to marking up and drilling the outriggers its is a lot easier,
Also keep checking that you can still open and close all the the doors,as my doors were quite perferctly straight.
-
Thanks - that was my plan. Did one of the holes line up with the existing trim securing stud hole? It looks as though it should.
I have found that if you pick the sliders up by the flange that bolts to the sill the slider side tends to hang down, so a couple of scissor jacks under that will mean that I can get the outrigger holes spot on.
Also, do they bolt to the outriggers in front or behind? The outriggers have rolled edges which would make it difficult to connect the sliders solidly if placed aft of them, but I'm just checking that I've not missed anything.
-
Planning to use a couple of scissor jacks to support the sliders while I work
I did this on mine (Discoparts), just watch they don't slide off because they're heavy! Ask me how I know.
fractions of a millimetre
On a Landy? Not even the engine is built to those tolerances.
:oops: :oops: :oops: :oops:
-
Haha! Well, even if the rest isn't then I can still make sure I get these straight. :D
I don't intend going underneath until I have the bolts through the sill sorted out. That should be a pretty effective way of ensuring they don't fall off the jacks.
-
Also, do they bolt to the outriggers in front or behind? The outriggers have rolled edges which would make it difficult to connect the sliders solidly if placed aft of them, but I'm just checking that I've not missed anything.
To answer your question the sit flat on the unrolled side of the outrigger, but it is sometime tricky to drill through on that side, so you have to drill through and hope they line up,
Also trial fit them before any drilling, mine needed a tweak as the outrigger wasnt in the right place
-
Thanks again - I will find some way to drill through from the flat side of the outrigger as it's a bit irrepairable if you get it wrong!
Would "tweak" mean "good belt with a big hammer"? :lol:
-
It was a bigger tweak that that, It was ground off and rewelded, but it now fits nicely
-
Slight change of plan after "a few holes" turned out to be "we're rebuilding your sills with box section"! The chap doing the welding is going to have a crack at fitting them at the same time as he's got a lift and is more experienced with metalwork than I am.
Feeling bad now, I've only managed to fit a handful of the mods myself! Chequerplate is next, I might manage that. Only a small drill bit and some silicone around the edges of them to stop mud getting in...