Mud-club

Vehicle & Technical => Defender => Topic started by: jimthelandyman on March 07, 2009, 19:28:33

Title: Diff swap problem
Post by: jimthelandyman on March 07, 2009, 19:28:33

I recently fitted a rear axle off a disco and the diff had the new type diff with the rubber donut on the flange, so i changed the flange for a four bolt flange and it did not take up all the play in the pinion shaft. Are the diffs different or am i missing something like a spacer ? cheers

Title: Re: Diff swap problem
Post by: turbonutter on March 07, 2009, 23:46:37

if i remember correctly there is a spacer ring that sits behind the prop flange

Title: Re: Diff swap problem
Post by: biggerlandy on March 08, 2009, 00:24:12

yes you should have a spacer or what i do is get the old 3 bolt flange you will see it is longer than the 4 bolt flange with a hacksaw cut of the extra bit on the longer plus a bit more say about a mm extra then you will have your spacer

Title: Re: Diff swap problem
Post by: jimthelandyman on March 08, 2009, 22:11:09

good idea will do that this weekend i need 4 wheel drive back desperatly cheers.