Mud-club

Vehicle & Technical => Discovery => Topic started by: stretchy on December 21, 2009, 22:17:13

Title: one shot leaking onto disc
Post by: stretchy on December 21, 2009, 22:17:13

alright guys Ive got one shot grease leaking onto the front break disc im pretty sure its oneshot and not ep90 although im not %100. the swivle seems fine thers no noking or noises could this just be a bearing seal ??

thanks guys

stretchy

Title: Re: one shot leaking onto disc
Post by: Range Rover Blues on December 22, 2009, 12:56:54

Sounds like a bit like pressurising in the hub so checkthe breather too.  Unless the hub sealis utterly shot it takes a little bit of positive pressure to blow one-shot out od the hub, although one-shot does thin a lot after a while.  Check that the one-shot isn't diluted by EP90 as it's possible that diff oil is being blown into the hub.

If you strip the hub out then check the stub axle for pitting at the area the oil seal should be seating on, invariably a worn stub axle or rusty one will nto seal against a new oil seal for very long.

As me how I know :(

Title: Re: one shot leaking onto disc
Post by: clover on December 22, 2009, 14:52:46

Is it your 0.99p garden centre DIY extended breather pipes? ROFL!!!

If its EP90 then the inner bearing seal is fubar. Remember we had to change mine for exactly the same reason.

Title: Re: one shot leaking onto disc
Post by: stretchy on December 22, 2009, 21:38:14

hahaa say what you will .. id use macdonalds straws if they wear longer  :dance:

Title: Re: one shot leaking onto disc
Post by: tack43 on December 22, 2009, 21:46:15

Also check your swivel pins for play/loose bolts as this will move the seal off the chome ball.

Rich