Mud-club

Chat & Social => The Bar - General Chat => Topic started by: kizz81 on April 02, 2010, 00:36:41

Title: series 2a amulance body into trailer?
Post by: kizz81 on April 02, 2010, 00:36:41

hello,
how difficult would it be to make a ambulance body into a trailer, it doesnt have to carry much weight, i will do my trailer test before hand, just needs to be good and safe to tow,
cheers kieran

Title: Re: series 2a amulance body into trailer?
Post by: sMUDge on April 02, 2010, 03:27:15

Currently doing that mate, with a 109 Ambi body  :dance:

http://www.mud-club.com/forum/index.php/topic,77507.0.html (http://www.mud-club.com/forum/index.php/topic,77507.0.html)

http://www.landroveraddict.com/smf/index.php?topic=385287.0 (http://www.landroveraddict.com/smf/index.php?topic=385287.0)

I'll keep you informed  :D

Title: Re: series 2a amulance body into trailer?
Post by: kizz81 on April 02, 2010, 20:32:38

i was eying that up on your origional post on the spotted section for that very purpose  :lol: :lol:

i think it would look good with the front overhang cut off, and behind an ambulance  :lol:

Title: Re: series 2a amulance body into trailer?
Post by: Range Rover Blues on April 02, 2010, 21:19:20

You know better than most how much weight is already in the ambulance

Title: Re: series 2a amulance body into trailer?
Post by: kizz81 on April 03, 2010, 02:08:51

heavy !
andy, not related but the clutch fork has gone in pinky, any ideas how to wire in an efi? to the ragie my knee isnt up to a manual at the moment
( new clutch fork las year from britpart brought from paddocks, wonr be using either again as this is the second ne clutch failure from both this year! )
cheers kieran

Title: Re: series 2a amulance body into trailer?
Post by: Range Rover Blues on April 11, 2010, 23:43:19

Fit the cast iron clutch fork from a RRC