Mud-club

Vehicle & Technical => Defender => Topic started by: military mad 110 on May 04, 2010, 19:10:32

Title: 300 tdi injection pump
Post by: military mad 110 on May 04, 2010, 19:10:32

can anyone help? need to find out what position the mixture screw! the one you have to slacken the nut off on the back of the pump and turn with a screw driver! should it  be eg: "wind it all the way in and then wind it out 3 turns" etc.   as mines a bit Smokey and has been played with cheers

Title: Re: 300 tdi injection pump
Post by: Saffy on May 04, 2010, 20:04:54

its not a carburettor!

any how this might be of some use...
http://www.stonefisk.com/doc-arc/def_man/ThermoGuard_Tdi_Tuning_Rev.2.pdf

Title: Re: 300 tdi injection pump
Post by: military mad 110 on May 04, 2010, 21:40:50

still lost! i know how to adjust the diaphram one. its the one thats down at the back/side  were the pipes leave the pump and go to the injectors

Title: Re: 300 tdi injection pump
Post by: Range Rover Blues on May 07, 2010, 23:22:13

It's set with a meter, if it's too smokey you need to make small adjustament 'till you're happy but once you loose the setting it needs special equipment to get it back to the correct setting AFAIK (could be wrong).

Title: Re: 300 tdi injection pump
Post by: military mad 110 on May 08, 2010, 00:21:19

 AFAIK what is this? and to you wind it in or out to weaken it?

Title: Re: 300 tdi injection pump
Post by: Range Rover Blues on May 08, 2010, 12:23:23

as far as I know.  I think you screw it in t limit travel (fueling)