Radius Arms

[drum]

I've finally got myself the QT Radius Arms for the 110, and I've been browsing the book of lies on changine radius arms mainlt to get the torque settings etc.

However the book says that I have to disconnect the Track Rod at the ball joint. Do I actually have to do this I can't see the reason for doing it. It looks to me as if I only neead to do the one one Chassis Nut, and the two Axle\Radius Arm Bolts. So What am I missing??

[Xtremeteam]

you need to undo one of the trackrod ends as otherwise the radious arm wont come out as its in the way  
did a 110 today with new bushes

[drum]

I'd better have a look in the light tomorrow then, as I hadn't sussed that.

Also better find a ball joint splitter according to the book.

[Xtremeteam]

I'd better have a look in the light tomorrow then, as I hadn't sussed that.

Also better find a ball joint splitter according to the book.

naaaa
if you have a 2Ib hammer,undo the nut but leave it on to protect the thread & malky the hub where the TRE goes in & if you do it hard enough it will pop the Tre out,just dont hit the gatior