Pages: [1]   Go Down

AuthorTopic: Oh no, not again!!  (Read 945 times)

0 Members and 1 Guest are viewing this topic.

gords

  • Guest
Oh no, not again!!
« on: January 19, 2006, 00:02:49 »
Some of you may remember I had a rear diff problem last year.

Well, it's not the same problem ... but it is the same end :roll:  Apparently (according to new garage I used today), the pinion shaft has extensive travel in/outwards. It was very low on oil but I can't say I've noticed any dripping on the floor!? :-k

Anyway, based on the above is it worth looking to get the diff rebuilt/overhauled, or should I just look for a replacement from a breaker?

If I get a secondhand one from a breaker, is it worth getting the half shafts from the same axle (as they will be worn in the same way?!)?
Logged

Offline chuggaman

  • Posts: 872
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Oh no, not again!!
« Reply #1 on: January 19, 2006, 00:15:01 »
oops


thats the third one on the forum this month


see here                http://forums.mud-club.com/viewtopic.php?t=16683


mike
Logged
U.N.D.E.R.......C.O.N.S.T.R.U.C.T.I.O.N.......







http://members.mud-club.com/profiles/chuggaman/gallery/

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Re: Oh no, not again!!
« Reply #2 on: January 19, 2006, 00:50:15 »
Quote from: "gords"
If I get a secondhand one from a breaker, is it worth getting the half shafts from the same axle (as they will be worn in the same way?!)?


If the price is right then you may as well but I wouldn't say it's necessary.
There's always the risk that the ones you get from the breakers turn out to be worse than yours are, but if nothing else at least you'll have a spare set of halfshafts.  :D
Logged

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Oh no, not again!!
« Reply #3 on: January 19, 2006, 17:14:38 »
ISn't this a 24 spline diff?  If so you have a particularly good point about the wear, but as Budgie says you need to be sure they 'new' diff/shafts are at least as good as your old ones.  If not I wouldn't buy the diff.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Oh no, not again!!
« Reply #4 on: January 20, 2006, 09:19:01 »
Rebuilding the pinion needs a bit of care to do right... but at least if you do it, you know it's right.

The problem with getting another second hand one is that you never know if the bearings on it are just as bad.
Logged
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline davidlandy

  • Posts: 3568
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Oh no, not again!!
« Reply #5 on: January 20, 2006, 09:22:37 »
Gords

get one from ashcrofts - no worries then, quality stuff
Logged
Dave
Sniff, sniff, this mud smells funny

gords

  • Guest
Oh no, not again!!
« Reply #6 on: January 20, 2006, 11:46:15 »
Quote from: "davidlandy"
Gords

get one from ashcrofts - no worries then, quality stuff

Possibly ... £255 + VAT for a standard one, but
Quote
If you find you are breaking the stock diffs regulaly I would suggest looking at either the 4-pin diff or a limited slip or locking type.

A 4-pin diff is £325!

I'm waiting for a price from a local chap to rebuild mine - I'll then try and decide what to do! :roll:
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal