Pages: [1]   Go Down

AuthorTopic: Series 3 rear prop-shaft UJ size?  (Read 1585 times)

0 Members and 1 Guest are viewing this topic.

Offline scottydj2

  • Posts: 31
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Series 3 rear prop-shaft UJ size?
« on: January 23, 2006, 20:37:40 »
Hi.

I need to order a couple of replacement UJs for my rear prop-shaft.

I *think* a 1979 is the later larger size UJs, but not sure (and can't measure at the moment).

Anyone know which before I order the wrong size  :?

Cheers,

Scott
Logged
Vulture 19, MM0SPL
1976 101 Ambi/Camper - MORPH - Still undergoing refit.
1979 SWB Series III - 'The Landie' - New parabolics & shocks to be fitted.
1990 Rangie Vogue 3.9 - Morph's new engine?
Niva Cossock - Storage shed!

Offline scottydj2

  • Posts: 31
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Series 3 rear prop-shaft UJ size?
« Reply #1 on: January 24, 2006, 16:08:44 »
Answering my own questions again  8)

It's the larger 3 and 3/16 size.


Scott.
Logged
Vulture 19, MM0SPL
1976 101 Ambi/Camper - MORPH - Still undergoing refit.
1979 SWB Series III - 'The Landie' - New parabolics & shocks to be fitted.
1990 Rangie Vogue 3.9 - Morph's new engine?
Niva Cossock - Storage shed!

Offline James.Harwood

  • Posts: 303
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Series 3 rear prop-shaft UJ size?
« Reply #2 on: January 28, 2006, 20:44:43 »
For the extra cost it would probably be worth replacing the entire shaft.  I replaced front UJ's just to have the slider sieze 12 months later and take out the splines.  

A 1979 is probably going to be fun as some parts were fitted and tested for defenders about then (found that out on Inked ravens 88") and were not in the S3 parts manual.
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal