AuthorTopic: Low power  (Read 1121 times)

0 Members and 1 Guest are viewing this topic.

Offline Pike

  • Posts: 125
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« on: March 20, 2006, 23:04:48 »
while im still awake can anyone shed any light on this one?.....when ive started my 200 from cold it ticks over fine,but I have problems getting it to rev up for the first couple of minutes,then its fine but also it seems to be lacking in power the further up the rev range I go,its not cos its running on veg oil cos it did it on normal diesel,ive changed the diesel filter,could it be owt to do with the sedimenter at the back?it doesnt blow any smoke out (more than normal)
it pulls fine at low speeds but seems to be lacking at higher speeds,it doesnt use any oil or water and its not noisy
ex disco owner....soon to be a 90 owner

Offline strapping young lad

  • Posts: 3326
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #1 on: March 20, 2006, 23:34:05 »
air flow ok?

if so...
injectors is where i would go next.

Offline Jim-Willy

  • Regional Rep
  • *
  • Posts: 2750
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #2 on: March 21, 2006, 00:25:41 »
My 300 is numb as a boat horse for the first five minutes until it warms up on cold mornings.  I just thought that was normal.
'ear all, see all, say nawt; Eyt all, sup all pay nawt; An' if ivver tha does owt fer nawt; Allus do it fer thi sen.

     

Offline wizard

  • Posts: 1095
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Cardiff. In the land of our fathers, so i am told
  • Referrals: 0
Low power
« Reply #3 on: March 21, 2006, 07:57:33 »
Check the fuel lift pump. could be on its way out.

wizard :twisted:

Offline Pike

  • Posts: 125
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #4 on: March 21, 2006, 10:28:30 »
its not airflow(changed the air filter),how do you check the lift pump?also changed the diesel filter again (had some s**t in it),just booked it in 4 the inner wings doing cos they are like a sieve on both sides,so bad that when i offroad all the mud ends up in the engine bay and not the wheel arch!!!!....£80 a side ok I suppose ....................I dont think it will be landrover next time!!!! :-({|=
ex disco owner....soon to be a 90 owner

Offline chris9119

  • Posts: 1400
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • The New Big Boy, Gert...
    • Lordswood, Kent
  • Referrals: 0
Low power
« Reply #5 on: March 21, 2006, 12:44:27 »
Pike

On the side of the lift pump, there should be a lever. If the resistence is low, then the pump could be us.

You could try putting an electric pump in to see if its any better/to confirm that your lift pump is u/s.

Chris
Chris
Si hoc adfixum in obice legere potes, et liberaliter educatus et nimis propinquus ades

http://members.mud-club.com/profiles/chris9119/gallery

Mud-Clubbers do it on channel 30






Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Low power
« Reply #6 on: March 21, 2006, 12:59:26 »
For the low power problem: Check the intercooler & turbo pipes for holes, splits and delamination on the inside. Make sure you can hear/feel the turbo cutting in. It's also worth checking the small pipe that runs from the turbo to the top of the injector pump for splits, as this will stop the injector pump going to full fuel as your rev increase, it'll feel like the turbo isn't working!

Try cleaning the intercooler as well, that makes quite a difference if it's not been done for a while!

Starting problem, lift pump or injectors would be the first place I'd start (as suggested above).

Offline Pike

  • Posts: 125
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #7 on: March 21, 2006, 13:27:55 »
checked the pipe from turbo,its ok,checked the lift pump,the lever on the side doesnt seem to doin much,it moves up and down but theres not much resistance at all,when you press the lever down is it supposed to come back up?it just seems to waggle around,taken the sedimenter off and was reasonably clean.......help
ex disco owner....soon to be a 90 owner

Offline BrumLee

  • Posts: 843
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #8 on: March 21, 2006, 16:08:18 »
Quote from: "Pike"
checked the pipe from turbo,its ok,checked the lift pump,the lever on the side doesnt seem to doin much,it moves up and down but theres not much resistance at all,when you press the lever down is it supposed to come back up?it just seems to waggle around,taken the sedimenter off and was reasonably clean.......help


You may need to turn the engine a bit more as the pump operates on a cam. It may be in the depressed state.
Lee from Brum

Offline Tyke

  • Posts: 582
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Low power
« Reply #9 on: March 22, 2006, 09:09:09 »
Would do as Budgie says and check the intercooler, not just the pipes, take the element out and give it a good clean and flush out.

Did my intercooler last weekend as the motor was starting to feel tired.

Has made a proper difference . . . . .  revs clean and pulls well again now.
----------------------------------

KEEPING IT REAL - KEEPING IT BRITISH


Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Low power
« Reply #10 on: March 22, 2006, 14:52:44 »
ALL diesels are crap when cold as they rely on heat to ignite the fuel.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal