the rear axel givin me some greif changed stub axels and all bearings got second hand disks (idiot) problem is the hub wont stay were its suposed to be I E after putting it back to gether it runs fine then rumbeling take off wheels and i can pull disk back n fourth surely this not right changed all necery parts and tightend as tight as it will go approx 300lbs
and still same probs too much play in the disk after a few miles .
can any body tell me how far the race bearing should go into the disk I.E right up to center or just in and the tightend .please some body must know any help welcome thanks
