Topic: any heating engineers? (Read 483 times)

bezzabsa · « **on:** October 07, 2006, 20:10:58 »

we have a back boiler - no idea which make as its ex council house - and i think they brought job lots of anything!
anyway problem is - nights getting colder, go to turn the heating on and NOTHING.. checked the fuse in the timer switch - bingo fuse gone, so swaps fuse turns on and BANG.. blows the fuse - and trips the circuit. worked ok before we turned it off during summer. problem is we dont have a seperate immersion heater - so no back boiler no hot water.. (luckily we have a shower)
anyone with any ideas????

barmiebrumie · « **Reply #1 on:** October 07, 2006, 21:12:40 »

You have a pm, we have a new member soon to be joining us & ghess what :?: he works for the Grittish Bass :D & had a bit of welding done on his disco at the maintenance day today

tonycougar · « **Reply #2 on:** October 07, 2006, 21:34:47 »

Its a while since my house had a back boiler, but it did have a pump in the electrical circuit. If the pump has stuck/seized then it may keep blowing the fuse.

seph234 · « **Reply #3 on:** October 07, 2006, 21:57:45 »

yes id be looking at freeing up the pump.

Mark2Disco · « **Reply #4 on:** October 07, 2006, 22:09:22 »

start with the pump
disconect wires and then put new fuse in and see if it blows
do the same with any other electrical componants on system
ie motorized valve, room stat ,cyclinder stat ,timer or even the boiler

ozzycraig · « **Reply #5 on:** October 07, 2006, 22:52:44 »

just started training as a heating engineer, will be a while til im qualified :(

i had the same problem with my pump, a couple of taps with a hammer had it spinning again though :D

News:

AuthorTopic: any heating engineers? (Read 483 times)

bezzabsa

any heating engineers?

barmiebrumie

any heating engineers?

tonycougar

any heating engineers?

seph234

any heating engineers?

Mark2Disco

any heating engineers?

ozzycraig

any heating engineers?