Pages: [1]   Go Down

AuthorTopic: 15" wheels  (Read 9861 times)

0 Members and 3 Guests are viewing this topic.

Offline muddysteve

  • Posts: 931
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« on: October 30, 2004, 23:17:34 »
do 15" steel wheels fit on a disco?

makes getting tyres a lot easier if you can

Steve
Logged
Steve                www.lanerovers.co.uk    www.surreyoffroaders.co.uk

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #1 on: October 30, 2004, 23:21:42 »
Yep, should do

I run 15" rims on the 90
Logged
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline muddysteve

  • Posts: 931
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #2 on: October 30, 2004, 23:27:02 »
i'm not going to run into problems with the discs/calipers then?

jsut want to make sure before i go writing my xmas list


Steve
Logged
Steve                www.lanerovers.co.uk    www.surreyoffroaders.co.uk

Offline toger

  • Posts: 237
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #3 on: October 30, 2004, 23:30:24 »
Quote from: "muddyweb"
Yep, should do

I run 15" rims on the 90


What's the benefit other than easier access to tyres please muddyweb :?:
Logged
Regards
Toger
2001 Disco2 Td5
www.onthelashwithtoger.com

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #4 on: October 30, 2004, 23:34:56 »
Quote from: "muddysteve"
i'm not going to run into problems with the discs/calipers then?


Don't see why you should... essentially the same axles.

I like the 15" rims because they allow the tyre to be more flexible (since there is more sidewall) and they tend to be a bit more compliant when running over obstacles.

I also find that you don't need to air-down as much with the taller sidewalls as the tyre spreads more than a 16"

Plus, as has been mentioned, there is a good selection of sizes.
Logged
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
15" wheels
« Reply #5 on: October 31, 2004, 01:14:14 »
It's not just the amount of choice, the prices for 15" tyres are much better too.
Can't understand people spending a grand to put 18" alloys on an off-roader.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline MUSKIE

  • Posts: 232
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #6 on: October 31, 2004, 10:16:11 »
Quote from: "Range Rover Blues"
It's not just the amount of choice, the prices for 15" tyres are much better too.
Can't understand people spending a grand to put 18" alloys on an off-roader.


yes but people spending a grand on alloys for there rangie arnt planning any off road work. its a case of you pay your money and drive what you like regardless of whether it goes offroad or not. i must admit if i had a p38 it would be alot of money tied up for me and i couldnt justify going off road in it, although it is capable. i know to alot of people a p38 is old hat now but to me it would still be an expensive car.
Logged

Offline muddyweb

  • Posts: 6382
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
15" wheels
« Reply #7 on: October 31, 2004, 10:37:24 »
I can't understand anyone spending a grand on putting alloys on anything  :shock:

Then again... I am a cheapskate  :lol:
Logged
Tim Burt
Muddyweb
-------------------------------------------------------------------------------------------------------------------
www.muddyweb.com
-------------------------------------------------------------------------------------------------------------------

Offline fesuvious

  • Posts: 395
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • water water everywhere, oh sh*t, Iv stalled it
  • Referrals: 0
15" wheels
« Reply #8 on: November 01, 2004, 16:47:12 »
Im running 15's - orrible cheapy white spokes.

But when you 3ft in [!Expletive Deleted!] your sure glad they are orrible cheapy white spokes :lol:  :lol:
Logged
Recommended wading depth 500 inches, no wait, im sure that was milimetres. And let me get this right. The breakover angle is 80 degrees....??

Ahh, f**k it, Il give it a go anyway
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal