Pages: [1]   Go Down

AuthorTopic: Another ABS issue  (Read 871 times)

0 Members and 1 Guest are viewing this topic.

Offline BigA

  • Posts: 597
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« on: February 17, 2007, 10:06:45 »
ok, my abs light is on in my 1995 300TDI Disco, now i think its because one of the front sensors is not seated correctly, therefore too big an air gap? But...... i found the ABS blink test in the workshop section, and thought, yes great i can do that, printed it off, and off i went to do the test. Found ABS relay no problem, disconnected as instructed, opened up the drivers side fuse panel to locate the blue diagnostic plug, and here is my problem, i cant find it, or anything looking similar.

Any suggestions please, i thought this was going to be too easy  :?

cheers in advance,

Andy
Logged
1978 Series III 88"

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Another ABS issue
« Reply #1 on: February 18, 2007, 01:04:34 »
I went looking for the EFi plug opn my softdash and I had to remove the underside kick panel and unwrap it fromm the loom.  If it has never been used it might be trapped alongside the wiring as it was installed, worth a look.

If you can't find it I can look on the Rovacom help pages for you, pm me if you get stuck.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline BigA

  • Posts: 597
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« Reply #2 on: February 18, 2007, 08:36:52 »
Quote from: "Range Rover Blues"
I went looking for the EFi plug opn my softdash and I had to remove the underside kick panel and unwrap it fromm the loom.  If it has never been used it might be trapped alongside the wiring as it was installed, worth a look.

If you can't find it I can look on the Rovacom help pages for you, pm me if you get stuck.


Thanks mate i will take another look, i didn't want to start tugging on looms unless sure it would be there, i will take another peek.
Logged
1978 Series III 88"

Offline Matbrown

  • Posts: 52
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« Reply #3 on: February 22, 2007, 11:06:36 »
Mine didn't have one either, looked everywhere for it!


Mat.
Logged

Offline BigA

  • Posts: 597
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« Reply #4 on: February 22, 2007, 18:11:11 »
Quote from: "Matbrown"
Mine didn't have one either, looked everywhere for it!


Mat.


hmmmmm...... could be fun resetting the error then  :?
Logged
1978 Series III 88"

Offline dazzawhipple

  • Posts: 936
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« Reply #5 on: February 22, 2007, 19:19:25 »
Put a bit of tape over the bulb






only joking
Logged
G'Day
Landcruiser 2004 , 4.2 Straight six, Diesel, Roo bar, Snorkel, Dual Batteries, UHF, Roof Consul, Rear Drawer storage system, 50mm Lift

Offline Matbrown

  • Posts: 52
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Another ABS issue
« Reply #6 on: February 23, 2007, 01:21:41 »
Quote from: "BigA"
Quote from: "Matbrown"
Mine didn't have one either, looked everywhere for it!


Mat.


hmmmmm...... could be fun resetting the error then  :?


I had to get it on the machine at LR.


Mat.
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal