110 cv and shaft options, maybe a revisit

[markyb]

out for the first proper play today at slab and broke the front axle in the space of 5 mins,  :(

i suspect its the long shaft as i checked the short shaft ,

i do have 10 spline and looking about theres 24, however cvs look strong and i hear the early cvs are stronger.

can i mix match my cvs with some 24 spline shafts or what do you recomend to run, will sort side gears onthe diff if needbe


i reckon i was just unlucky i didnt really give it big guns and it was on sand, i run 33.12.50 kumhos so they arent mega agressive,
i dont know the history of it so could have been waiting to break.

i will drop out the shaft tuesday have a look but i did manage to drive home in difflock with none of the nasty sounds you would expect from a broken shafts, maybe the broken piece retracted abit into the diff so it aloowed it to clear the broken shat,

anyway waffling again , cheers for any imput

[extreme90]

well if your 110 is a early 110
it will have......
10 spline shafts, with the strongest std lr cv available AEU2522's  
so its a 23/24 spline type cv
however, the only mix and match you can do to go 24 spline shaft is to uprate your shafts to the h/d type
these are avalible from ashcroft transmission's
but you were unlucky  
i dont see the need for you change the setup in the front, just stick a new h/s on the end
if your struggling source a shaft, i got about 10 here that i dont use as ive got h/d shafts all round
dont no if that made anysense as i tend to waffle on  :roll:
 :lol:
dan

[paul_humphreys]

Have a look at the number stamped on the axle, if it starts 20l then you have the AEU2522's CVs fitted. They were the strongest fitted by LR.

Paul

[markyb]

thanks. I wil pick up some etc spares too as 5mins after paying my 25 quid was a bummer but it was for a Mac millian shame your Stoke on trent and im basingstoke.  :-)

[extreme90]

:lol:
can i reccomend this tho  
saves absolutely bl***y hours in time , taking both sides apart and the diff out
http://www.x-eng.co.uk/X-Shaft.asp?MID=33
dan

[Xtremeteam]

:lol:
can i reccomend this tho  
saves absolutely bl***y hours in time , taking both sides apart and the diff out
http://www.x-eng.co.uk/X-Shaft.asp?MID=33
dan

but wont work in conjunction with standard shafts as they mash up to much,works brill with HD shafts as they snap so much cleaner

[extreme90]

worked with my twisted shafts many of time  :roll:

[extreme90]

](*,)  ](*,)  doh, shouldnt hae said that  :roll:   :oops: