Pages: [1]   Go Down

AuthorTopic: Which Plasma Cutter??  (Read 421 times)

0 Members and 1 Guest are viewing this topic.

Offline L90OOK

  • Posts: 1252
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Somerset
  • Referrals: 0
Which Plasma Cutter??
« on: March 20, 2007, 16:33:40 »
I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too   :?
Cheers
Logged
Did everyone see that?  Because I will NOT be doing it again!

 

Offline Bulli

  • Posts: 1694
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Which Plasma Cutter??
« Reply #1 on: March 20, 2007, 17:03:02 »
these things never seem to go cheap, no doubt someone will no where you can get one though!
Logged
EFILNIKCUFECIN
Disco V8 3 dr - THROW ME A FRICKIN' BONE HERE.
3 link, lockers and 35's- NUFF said

Offline muddydisco

  • Posts: 307
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Which Plasma Cutter??
« Reply #2 on: March 20, 2007, 18:44:21 »
Quote from: "L90OOK"
I want to get myself a plasma cutter for chassis, bodywork & fabrication of my own vehicles.
However...I have no experience of these machines :roll:
So...Your input on a good machine would be welcome...cheaper the better too   :?
Cheers


Which one are you thinking of going for the one with the built in compressor or not. I would go for the one with the built in compressor. There one called the drag-gun picture of a dragon i here these are great.

It's on ebay item numer 280093846256
Logged
YOU BEND IT YOU MEND IT

Offline Xtremeteam

  • Regional Rep
  • *
  • Posts: 6476
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Its just the way i roll
    • lampeter, west wales
  • Referrals: 0
Which Plasma Cutter??
« Reply #3 on: March 20, 2007, 18:59:45 »
got a snap on one which runs of the garage compressor,wasnt cheap looking at £500 to buy it 2nd hand now & over 1k new
Logged
Mike
I can Drive.. You can criticize..
I too can criticize like you.. but can you Drive like me??

Offline L90OOK

  • Posts: 1252
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Somerset
  • Referrals: 0
Which Plasma Cutter??
« Reply #4 on: March 20, 2007, 19:12:25 »
Cheers guys

I was looking at under £500 if possible...I have a compressor so either machine would be ok.
Have been looking on flea bay but don't know the pros & cons of each machine!  :?
What sort of Amperage sould I be going for?
Thanks
Logged
Did everyone see that?  Because I will NOT be doing it again!

 
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal