Pages: [1]   Go Down

AuthorTopic: changing swivel bearings without striping the hub?  (Read 782 times)

0 Members and 2 Guests are viewing this topic.

Offline windowlicker

  • Posts: 228
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
changing swivel bearings without striping the hub?
« on: March 31, 2007, 10:48:21 »
i was wandering if its possible to change the swivel pin bearings and seals without striping the hub the main reason is that when i changed the wheel bearings the threads on the stub axle were not briliant and i dont want to risk completely knackering them by taking the hubnuts off and on again.

its a kit that i got from paddocks but where does the little oil seal fit does anyone have an exploded diagram?
Logged

Offline hobbit

  • Posts: 4750
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
changing swivel bearings without striping the hub?
« Reply #1 on: March 31, 2007, 11:38:24 »
pm for you
Logged
Kev

'91 stretch Discovery 200 Tdi
Hybrid for running round (got to go now)
Srs 3 Lightweight petrol (got to go)
Srs 3 Lightweight petrol, runabout

Not every problem can be solved with duct tape, and it's exactly for those situations we have WD 40

Offline andyb

  • Posts: 412
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Tilshead, Wiltshire
  • Referrals: 0
changing swivel bearings without striping the hub?
« Reply #2 on: March 31, 2007, 12:21:13 »
I'd bite the bullet and get a stub axle as well and 'do it properly' :)

The new surface on the stub axle will help with the oil seal sealing at the back of the wheel bearings and will be well worth the extra cost given the extended life that your wheel bearings will enjoy.

Just 2p worth :)

HTH
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal