Pages: [1]   Go Down

AuthorTopic: Fitting a bull bar  (Read 1273 times)

0 Members and 1 Guest are viewing this topic.

Offline kuli1985

  • Posts: 38
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Fitting a bull bar
« on: April 13, 2007, 17:13:30 »
Does anybody have any pictures that they could post of exactly where a bull bar / A bar fits on a vitara.  My vitara is P Reg 1996, and i cannot identify where the bar fits..the only place where i believe it could fit, you are unable to bolt to as you can only access the hole from one side.

Any advice would be great, thanks.

CK
Logged
Kuli
Yorkshire Born and Bred

Offline Evilgoat

  • Posts: 2786
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Fitting a bull bar
« Reply #1 on: April 13, 2007, 17:21:41 »
Good that Innit ? :)

Took me ages. If its the same as my full size bard, you have two U clamps that go over the crossmember at the front, then 2 M8 bolts into the chassis rails through the bracket.

Got a pipc of what youv'e got?
Logged
I must confess the the activities of the UK governments for the past couple of years have been watched with frank admiration and amazement by Lord Vetinari. Outright theft as a policy had never occured to him.

-- (Terry Pratchett, alt.fan.pratchett)

EX HK Police Mitsubishi Pajero 2.8TD
Audi S2 Avant 360bhp
Transit LWB 2.5di (The Shed)

Offline kuli1985

  • Posts: 38
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Fitting a bull bar
« Reply #2 on: April 13, 2007, 17:46:03 »
thanks for that...cant get any pics cus my camera has gone walkies..do you have any pics at all that you could post up? I can see the chassis rails but they can only be accessed from oneside and so how do you bolt onto them?
Logged
Kuli
Yorkshire Born and Bred
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal