Pages: [1]   Go Down

AuthorTopic: Blanking Plate  (Read 1883 times)

0 Members and 1 Guest are viewing this topic.

Offline benbenukuk

  • Posts: 179
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Blanking Plate
« on: July 21, 2007, 10:34:53 »
Hi All, A have just brought a tubular exhaust system inc manifold but need to get a blanking plate for the inlet manifold where would I get one or how could I make one? :?:  Many Thanks.  Ben
Logged
1989 3.5 v8 range rover classic with 3.9 efi system, 6'' lift, +5'' dampers, dislocation cones all round, 12500ib T-Max winch, steering guard, custom made rock sliders, light pod, custom made side exit exhaust, welded front and rear diff guards, full roof rack, 35/12.50R15 BFG Muds, CB Radio, Twin Batteries, Rear ARB Locker :)

Offline ian_s

  • Posts: 969
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Blanking Plate
« Reply #1 on: July 21, 2007, 23:52:13 »
isnt it just a flat sheet of metal with 4 holes in the right places for the bolts?
cant be too hard to make
Logged
series 3 - 200tdi
Discovery V8

Offline dave_2A_2.25Turbo

  • Posts: 811
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Blanking Plate
« Reply #2 on: July 22, 2007, 23:49:30 »
Get yourself an SU or twinchoke Weber conversion instead....
Logged
Dave
1963 S2A
1992 Disco 200TDi
Sankey Widetrack

Offline philbert

  • Posts: 212
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Blanking Plate
« Reply #3 on: July 23, 2007, 22:16:18 »
Quote from: "dave_2A_2.25Turbo"
Get yourself an SU or twinchoke Weber conversion instead....


gotta agree with this get an su conversion.
as for a plate i think youll find the inlet manifold does not need it!
it is only a void and not through into the inlets.
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal