Pages: [1]   Go Down

AuthorTopic: lifting  (Read 987 times)

0 Members and 1 Guest are viewing this topic.

Offline ned

  • Posts: 3
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lifting
« on: September 04, 2007, 21:57:05 »
whats the most i can lift my disco before i need to start changing other parts any advice wellcome thank Q
Logged

Offline Steve ray

  • Posts: 893
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lifting
« Reply #1 on: September 04, 2007, 22:18:49 »
A 2" lift should mean you'll get some dcent ground clearnace by fitting largers tyres (say 32" or 265/75x16 Muds). However, all LR's are 'slightly different' ... I've know people lift motors and they still handle fine, others have been lifted jsut two inches and they are all over the road.


If you are going to lift, (in my opinion) its best to fit castor corrected radius arms along with cranked rear arms, extended brakes hoses, cones and possibly new poly bushes too.

Hope this helps mate
Logged
Sponsor us for the 2010 MAC 4x4 UK Challenge (5-7 March) www.justgiving.com/teambofa4x42011

Offline lee celtic

  • Regional Rep
  • *
  • Posts: 2680
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lifting
« Reply #2 on: September 04, 2007, 22:34:46 »
I lifted mine 2" all I changed were springs dampers and brake lines and it's been fine :D steering still centres and handles brill..

I will do mre as fund permit but it is somthing you can do bit by bit.
Logged
so many hills , so little time ....
discovery TD5
work in progress...lol

Offline Steven

  • Posts: 1388
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lifting
« Reply #3 on: September 05, 2007, 19:25:42 »
Quote from: "Steve ray"
A 2" lift should mean you'll get some dcent ground clearnace by fitting largers tyres (say 32" or 265/75x16 Muds). However, all LR's are 'slightly different' ... I've know people lift motors and they still handle fine, others have been lifted jsut two inches and they are all over the road.


If you are going to lift, (in my opinion) its best to fit castor corrected radius arms along with cranked rear arms, extended brakes hoses, cones and possibly new poly bushes too.

Hope this helps mate


Thats a pricey option  :shock:
Logged

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15221
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
lifting
« Reply #4 on: September 06, 2007, 12:35:11 »
When people ask me I always say you need to be prepared to spend £800 on doing the job right.  Some people find they don't, great for them, but some people do and for them the springs and shocks are only hlaf the cost.

A compramise might be to fit a 1" llift, or even just new or H/D springs which put the car back where it should be.  A 1" lift will not effect anything badly enough to worry.

BTW, fit up to 2" longer dampers on a standard car, but then you need to think about brake lines anyway.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline ChrisV8

  • Posts: 460
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
lifting
« Reply #5 on: September 06, 2007, 13:22:43 »
:lol: My Rangie has a 2 inch lift and there are no bothers at all and I run 235/85 x 16 tyres which are a good compromise in my opinion.
Logged
1982 Range Rover 200tdi inside
1993 LR 90 rebuild Project
2008 Jeep Patriot wondrous 45mpg VW diesel powered 4x4 road car
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal