AuthorTopic: jimny problem after water pump done  (Read 1228 times)

0 Members and 1 Guest are viewing this topic.

Offline jamesey

  • Posts: 553
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • land rover recovery service.
  • Referrals: 0
jimny problem after water pump done
« on: September 27, 2007, 02:07:14 »
hi ive done my pump but now the rad seem to stay cool all the time even after a drive the thermostat does open as i can feel the hot water gush in then it warms the rad for a bit then goes cool again
should it be hot including the bottom hose because at the mo there not
the temp gauge is at normal
ive run it with the rad cap off to see if its got any trapped air but got no joy from that
do me a favor and run your jimny till its hot then get out and feel the rad while its running and see if its warm ,hot or cold for me   thanks :wink:

wrecker

  • Guest
jimny problem after water pump done
« Reply #1 on: September 27, 2007, 21:21:49 »
hi ya mate,

while working on my mates jimmy hes was warm,,not hot after a 30 mile run,

hope this helps a bit mate :D

Offline glaggs

  • Posts: 472
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
jimny problem after water pump done
« Reply #2 on: October 01, 2007, 12:48:47 »
Jamesy, did you sit with the engin running on the drive, mine never seems to get hot enough this way, but take it for a short 3-4 mile spin and the heater etc is fine.
..V..

Offline jamesey

  • Posts: 553
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • land rover recovery service.
  • Referrals: 0
jimny problem after water pump done
« Reply #3 on: October 07, 2007, 23:14:53 »
seems to be hot on a short run but the bottom hose not that hot , im just living with it now , it doesnt seem to be overheating with the gauge

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal