Just thought i would post this as I've read posts where some people have found it hard to tighten up the brass nut on the back of the washer jet unit.
I did it with out removing half the top dash by taking out the radio and surround and the unscrewing the four screws on the black plastic guard that sits right behind the radio[Had to use a long shaft phillps and a short one].
Then you can see the brass nut and more importantly you can tighten it up.
To hold the washer block while tightening the nut i just taped it to the bulk head with electrical tape.
I was relived that i didn't have to take half the dash out because that's a pain.
Hope this helps anyone else who might have a loose washer jet block.
