AuthorTopic: fitting a battery cut off/immobiliser  (Read 1817 times)

0 Members and 1 Guest are viewing this topic.

Offline flash42

  • Posts: 213
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
fitting a battery cut off/immobiliser
« on: March 26, 2008, 09:39:01 »
looking at fitting a battery cut off/imobiliser switch to my defender 90 300tdi
firstly is it difficult to fit by hand.
and secondly where can i get the parts from.

cheers

flash

Offline vtrdaz

  • Posts: 460
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #1 on: March 26, 2008, 10:05:44 »
Try these :
http://www.vehicle-wiring-products.eu/VWP-onlinestore/home/homepage.php

They sell all thing auto electrical , with a good mail order service.

Darren

Offline Defender

  • Posts: 403
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #2 on: March 26, 2008, 17:02:52 »
You could try Demon Tweeks. They do a range of Battery Isolation devices.
The best place to mount it would be in the front of the passenger seat box so the cables can be connected to the rear of it in the battery box.
You will need to get a short length of cable made up to link the battery to the isolator. Then connect the cable that goes to the starter solenoid to the other terminal.
Paul.
GLASS Lancs & Cumbria Rep.
 

Offline Freelander1980

  • Posts: 162
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #3 on: March 26, 2008, 17:23:06 »
When you look at one, make sure you are getting one that cuts everything, a friend bought one, wired it all up started the engine and with a big grin flicked it expecting it to cut everything out  and then it dawned he had got an isolator not a cut off switch (if that all makes sense)

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #4 on: March 26, 2008, 18:31:17 »
An isolator on the battery will prevent it form starting or being bump-started  but as he says not jump started.  You can also get ones with a 5 amp fuse to keep the closk going but if someone tries to start it the fuse blows.  These are a good idea because it's then not as obvious that the battery is isolated 'till they try.

Also make sure your alarm is then wired direct to the battery.
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline Litch

  • Posts: 324
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #5 on: March 27, 2008, 20:33:55 »
The type you need is an FIA isolator, the key is removable and when you turn it you kill the engine, isolate the battery and protect the alternator. They cost about £22 and are easy to fit as long as you can follow a simple wiring diagram. Add a low capacity fuse to support the alarm etc.
I have fitted one to each of my LR's for 20-years and they have proved to be 100% reliable.
ONE LIFE, GET IT!

Offline extreme90

  • Regional Rep
  • *
  • Posts: 3219
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • say no to orange extreme bits !!
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #6 on: March 27, 2008, 22:31:16 »
The type you need is an FIA isolator, the key is removable and when you turn it you kill the engine, isolate the battery and protect the alternator. They cost about £22 and are easy to fit as long as you can follow a simple wiring diagram. Add a low capacity fuse to support the alarm etc.
I have fitted one to each of my LR's for 20-years and they have proved to be 100% reliable.

unless they are under water all the time  :lol: :lol:
damn i hate it when mine cuts out in water  :roll:
stupid challenge rules n regs state i have to have one though  :roll:
Dan Thomas,                  Matt Price
Team Relentless " No half measures "
Bobtailed Auto Td5 90 comp truck........... Got more tricks than a magician !!

http://www.Devon 4x4.co.uk >> for all your truck needs and more !!
http://www.Gigglepin4x4.net >> For when the going gets tuff, and one motor just isnt good enough !!!
http://www.gwynlewis4x4.co.uk >> the guy everyone forgets, but he doesnt forget your custom.

Offline kizz81

  • Posts: 1249
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: fitting a battery cut off/immobiliser
« Reply #7 on: March 27, 2008, 23:19:42 »
is it for vehicle security? if so then why not a key switch that intercepts the wire from the ignition to the starter motor ? maybe wire up a connection to the horn so that if some one goes to all the effort to smash and rewire your ignition when they touch the wires it beeps the horn, or even wire up a siren inside or something  :lol:

Ever dreamed about travelling to the land of the midnight sun? visit our website for more info!
www.freespirit4x4.co.uk

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal