Dizzy change.!!?

[R2D2]

Hi Guys.

Would like to change my Dizzy/coil/amp setup on the 3.5 rrc efi. mainly 'cos I keep drowning the amp on mine which is both expensive and located on the wing under the coil.

Have picked up, from a 3.5 efi 'H' reg (mine is a D reg) a  dizzy (with the smaller bolt on amp) plus the coil with all leads as well.  This car was running when it arrived at the breaker's yard.

So my question is:  Is it a straight swap and is the wiring an issue? 8-[  8-[


I know I will have to make sure the dizzy goes in on the exact same position as mine comes out or it may never run again  :shock: 

All advice welcomed.

[iomlr]

the wiring to the coil may be different as at the moment and guessing you only have 1 wire from the coil to the dizzy? could be wrong. but no biggy thou wack it in wire her up not rocket science and then she'll need timining up after.