Sankey Rear Legs

[landroverkeith]

 :-. what do i need to secure the rear prop stands in the legs of the sankey?

Finally ordered a pair for mine and lol well there fine in the up position lol just a tad unstable when down lol  :dance:

[hobbit]

What type?


and are you one about the inner slider parts?

[landroverkeith]

oopsss sorry yes the inner slide type like the ones in the 2nd photo

ta keith

[hobbit]

Not got the trailer near me at the mo, but basically its a large thread bolt with a piece of bar welded onto the bolt head at an angle, so you can spin it by hand

This goes through the inner leg and jams against the back of the outher sheath when tighened

[landroverkeith]

its just the slider i need to secure into the outer tube.

[hobbit]

ok finding an original part may be hard to find, but if you can source a bolt of the same thread as the insert, they you can weld a piece of bar onto it at an angle, job done

These trailers have 3 legs, if I'm right they are all the same on the clamps, take one of the other out and check the thread, then try a bolt supplier to match it

[landroverkeith]

ok finding an original part may be hard to find, but if you can source a bolt of the same thread as the insert, they you can weld a piece of bar onto it at an angle, job done

These trailers have 3 legs, if I'm right they are all the same on the clamps, take one of the other out and check the thread, then try a bolt supplier to match it

i have no threads of any description on the outer parts  8-[ its just 2 hollow tubes with a long slit cut into the tube from top to bottom i assume sumthing like u described early must literaly just slide into it and pin the leg ??

a very nice chap did give me a sankey leg like u describe that has threads and a wind down leg on it but it looks like its about 20 years newer than the ones on the sankey :)  looks to me like ill have to make some holes in the legs and a couple of nice bolts to hold at differant heights would be easyest

[hobbit]

The threading is on the inner leg not the outside tube, I wish I could find the spare one I have, hang on forgot I got one fitted to the tub trailer outside,