spacers

[lambert]

have interference on back wheels so get some spacers all good. however centre bore on spacers is too big for wheels to fit over, so do i mod the wheels to the sacers, the sacers to the wheels both needing a lathe i dont have or do i just remove the whole center ring with my grinder to give a fully flat face without any centering but for the studs?

[hairyasswelder]

modify spacer. The wheels will then still fit if you change your mind.
Plus the chuck needed to hold a wheel narrows down your options  ;)
Would not reccomend grinder as then all weight will be on the studs, the centre takes most of the weight.

[lambert]

had another look at the spacer and the axle and again the spacer is over size so all the load is on the studs anyway so i think i'll grind and be carfull.