Do P38 alloys fit a Disco 2?

[Matbrown]

As above, someone has offered me some wheels but they are from a RR P38 and i'm not sure if they will fit my 2000 TD5.
Does anyone know if they will?


Mat.

[solihull-mick]

Hi there, yes P38 rims will fit a disco 2 as long as you used the correct wheel nuts, 

[Disco Matt]

Not sure, but I have seen adapter rings mentioned? Suggestion seemed to be that they would fit, but needed these rings to enable you to tighten them up properly.

[Matbrown]

Thanks.


Mat.

[Disco Matt]

Ok, a little digging has found these http://cgi.ebay.co.uk/SPIGOT-RINGS-location-RANGE-ROVER-P38-alloy-wheels_W0QQitemZ300266325947QQcmdZViewItemQQptZLH_DefaultDomain_3?hash=item300266325947&_trksid=p3286.c0.m14&_trkparms=72%3A1301|66%3A2|65%3A12|39%3A2|240%3A1318

I think it's saying that you don't need them to put P38 wheels on a Disco 2, but are used to fit later wheels to those two vehicles.

[Range Rover Blues]

Knowing trhe BMW mentalisty it's very possible either could be true.  they forced LR to use the BMW spacing pattern even though it never stayed standard on their own cars, I reckon they do it to prevent you fitting newer wheesl to an older car.

[Spooky]

The P38 and the D2 share the same stud pattern - the wheels can be willy-nilly swapped between the 2 vehicles.  The wheelnuts are also the same.

The 'spigot rings' become necessary should you wish to fit D3, L322 or Sport rims onto a D2 or P38.  In this event, a new set of wheelnuts will also be required ...