AuthorTopic: Lights  (Read 849 times)

0 Members and 1 Guest are viewing this topic.

Offline mass199

  • Posts: 301
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Wye Valley
  • Referrals: 0
Lights
« on: May 10, 2009, 18:05:22 »
My 1990 front near side head lights are not working, dip or main.

Bulb replaced

fuses ok

Anything else i can try, all other lights on the vehicle are ok and all the earths seem ok

Help

Cheers Mark
Herefordshire LRC

Heads, Shoulders, Knees and Toes. All been smashed in MX crashes.

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Re: Lights
« Reply #1 on: May 11, 2009, 00:52:29 »
Side lights on the front & back on that side working OK?

Offline mass199

  • Posts: 301
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Wye Valley
  • Referrals: 0
Re: Lights
« Reply #2 on: May 11, 2009, 07:23:33 »
Yes all working ok.  No power at the fuse box. Looks like it could be a problem after the switchgear and before the fuse box

Any ideas
Herefordshire LRC

Heads, Shoulders, Knees and Toes. All been smashed in MX crashes.

Offline Budgie

  • Regional Rep
  • *
  • Posts: 2217
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • This post is best viewed on a computer.
    • Lochaber
  • Referrals: 0
Re: Lights
« Reply #3 on: May 11, 2009, 16:09:25 »
It's just a case of getting the wiring diagram and a tester and going through it until you find the problem.
Look to see what else is on the circuit, also look for any relays that power the lights as well. 

Offline ChrisW70

  • Moderator
  • ***
  • Posts: 785
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: Lights
« Reply #4 on: May 11, 2009, 16:18:56 »
Looks like it could be a problem after the switchgear and before the fuse box

Any ideas

It's quite common for the switches to breakdown on 200 Disco's - there's no relays in the loom so the power goes from battery via steering column switch to the headlamps - typically causes a bit of heat through the contacts after they become well worn and eventually breakdown of the switch.

Short term fix is a new switch, long term fix is a new switch and re-wire the existing feed to the back of the headlamps to switch relays and run a feed direct from battery to headlamp via the relay - this should make a marked difference in light output too.
Chris W

West Midlands Region GLASS Rep
GLASS TRO Officer

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal