AuthorTopic: td4 loss of power  (Read 6518 times)

0 Members and 1 Guest are viewing this topic.

Offline aaron

  • Posts: 72
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
td4 loss of power
« on: May 18, 2009, 21:04:32 »
Hi all,  just been for a drive in my mates 05 td4 so he could show me a fault with it. Intermittently at around 70mph or equivalent rpm, it just stops pulling and will not rev any higher. The engine warning light also comes on too, then as soon as the light goes out it revs harder. Any ideas anyone?
Ford ranger, daily driver.
Porsche 924 ongoing project, yet to drive!!
Suzuki X90 off roader.........also a project!!!

Offline Llanigraham

  • Posts: 610
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: td4 loss of power
« Reply #1 on: May 18, 2009, 22:25:13 »
EGR valve?
Crankcase breather?
Turbo pipes split?

Dpes it smoke when this happens?
MSA Radio: Worcester1

Offline pondy653

  • Posts: 126
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Norwich
  • Referrals: 0
Re: td4 loss of power
« Reply #2 on: May 20, 2009, 21:52:51 »
Been here myself and its a 30 quid fix!!!

Check out my post about half way down this page http://www.landyzone.co.uk/lz/f9/td4-power-loss-when-pulling-away-23216-10.html.  My 51 plate was exactly the same as you have described. found the above thread spent £30+vat at the main dealers, 1/2 an hour of my time and i now have a TD4 that regularly sees 3 figures on the speedo (confirmed by gps).

All you need is a 10mm socket. if you want a photo let me know.
Good luck

Tony

98 Defender 110 CSW Tdi
Audi A3 Sportback 2.0 TDI Sport DSG
Yamaha WR450F (for treading really lightly)
4x4 Response (Norfolk&Suffolk) Member since 1999

Offline JohanNaude

  • Posts: 1
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: td4 loss of power
« Reply #3 on: June 21, 2009, 20:02:16 »
Hi Boet,

I had a similar problem and took my 2005 Freelander to a friend who read the codes with his analyser and it came up as a fuel pressure sensor fault.
After cleaning the 3 wire connector on the end of the fuel rail  the fault dissapeared and it still going well after 5000 km
Hoping this might solve your problem

Regards
Johan

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal