Pages: [1]   Go Down

AuthorTopic: car won't start  (Read 1572 times)

0 Members and 1 Guest are viewing this topic.

Offline iann41

  • Posts: 36
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
car won't start
« on: February 12, 2010, 19:10:59 »
The disco won't start. its a 300 tdi, P reg. Power is getting to the starter motor but there's just a whirring noise. I don't think it's engaging. The electrics seem to be playing up a little (Alarm system). Can it be connected? I've also noticed a Heat/Burning smell latly. Smells something like over cooked brakes or clutch (mines an auto). Any info on a remedy. Thx Ian
« Last Edit: February 12, 2010, 19:14:43 by iann41 »
Logged
'P'reg 300tdi ES Auto with EDC

Offline trecfive

  • Posts: 457
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • If it fit's the hook it'll pull it.
    • Nuneaton
  • Referrals: 0
Re: car won't start
« Reply #1 on: February 12, 2010, 21:11:36 »
Engine to chassis earth cable not making a good connection.It will be earthing through the auto box gear selector cable,has the gear shifter got stiffer?
Logged
1. Range Rover Classic 300tdi SE Auto Softdash
2. Range Rover Classic 300tdi SE Auto Softdash, apparently very rare.

Offline iann41

  • Posts: 36
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #2 on: February 13, 2010, 06:19:15 »
not that i've noticed. Thx for the reply i'll have a look at the earth.
Logged
'P'reg 300tdi ES Auto with EDC

Offline ChrisW70

  • Moderator
  • ***
  • Posts: 785
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #3 on: February 13, 2010, 12:10:49 »
It can ground through the handbrake cable as well, could explain the burning smell?
Logged
Chris W

West Midlands Region GLASS Rep
GLASS TRO Officer

Offline David Gray

  • Posts: 10
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #4 on: February 13, 2010, 22:04:12 »
Try running a wire from battery Pos to starter sol. This will by-pass alarm system if engine turns over then it could be alarm system(SPIDER) unit just had to change the one on mine with similar problem.
Logged

Offline iann41

  • Posts: 36
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #5 on: February 14, 2010, 06:50:23 »
 I think i might need to change the spider wiring as other little things are occuring like the flashing of lights and bleeping seem to have stopped when i arm/disarm the alarm. How would i go about replacing it? I've took the starter motor off and all looks ok. I'll regrease it a little and refit. If i wanted a bosch motor where would i get one from and how much. Thx Ian
Logged
'P'reg 300tdi ES Auto with EDC

Offline David Gray

  • Posts: 10
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #6 on: February 15, 2010, 08:20:37 »
go onto google discovery 300 tdi wont start. theres a blow by blow description on there its a fiddley job but not impossible. Good luck.
Logged

Offline Bobtail

  • Regional Rep
  • *
  • Posts: 1215
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #7 on: February 15, 2010, 19:19:17 »
Logged
200 TDI Range Rover Classiic

Offline iann41

  • Posts: 36
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: car won't start
« Reply #8 on: February 17, 2010, 11:07:08 »
Took the dash apart to access the spider and it wasn't there. will i have one some where else. The disco has the problems associated with a faulty spider (sudden cut out, alarm/immobiliser problems, won't start) but i don't seem to have one. any advice? Thx Ian
Logged
'P'reg 300tdi ES Auto with EDC
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal