Pages: [1]   Go Down

AuthorTopic: p38 alloy problems  (Read 1517 times)

0 Members and 1 Guest are viewing this topic.

Offline military mad 110

  • Posts: 63
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • always a good excuse to get plastered in mud
    • torquay
  • Referrals: 0
p38 alloy problems
« on: June 13, 2010, 22:01:31 »
what wheels will fit my p38? have found a nice set of range rover stormers i like! but  have been told that newer ranger rover wheels wont fit it but in the advert it says will also fit a p38
Logged

Offline muddysteve

  • Posts: 931
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: p38 alloy problems
« Reply #1 on: June 14, 2010, 09:13:39 »
i think you need the later wheel nuts and some spigot rings for them to sit on the hubs properly
Logged
Steve                www.lanerovers.co.uk    www.surreyoffroaders.co.uk

Offline Range Rover Blues

  • Moderator
  • ***
  • Posts: 15218
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +3/-0
    • South Yorkshire
  • Referrals: 0
Re: p38 alloy problems
« Reply #2 on: June 14, 2010, 13:09:25 »
That's how I understand it too, the PCD is the same (the holes are in the righ tplace) but the centring spigot is different and the nuts might be too.
Logged
Blue,  1988  Range Rover 3.5 EFi with plenty of toys bolted on
Chuggaboom, 1995 Range Rover Classic
1995 Range Rover Classic Vogue LSE with 5 big sticks of Blackpool rock under the bonnet.

Offline piggysteve

  • Posts: 523
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: p38 alloy problems
« Reply #3 on: June 14, 2010, 16:34:04 »
I've done the opposite but had to vandalise the spigot rings to get them off the hub  :twisted:.
You can get them off ebay easily enough
Logged
Ex pat Yorkshireman.

P38 diesel

Offline military mad 110

  • Posts: 63
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • always a good excuse to get plastered in mud
    • torquay
  • Referrals: 0
Re: p38 alloy problems
« Reply #4 on: June 15, 2010, 07:31:57 »
so the stud pattern is the same?
Logged
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal