AuthorTopic: disco 1 3.9 V8 help needed..  (Read 3000 times)

0 Members and 1 Guest are viewing this topic.

Offline lee celtic

  • Regional Rep
  • *
  • Posts: 2680
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
disco 1 3.9 V8 help needed..
« on: March 18, 2012, 15:02:37 »
Hi.. I need some help.. I have a 96 3.9 V8 running on petrol not gas. It has been fine for months since buying it but it has developed a fault.

When I accelerate up to 2000 rpm it's like running on kangaroo juice (violent juddering stop start lunging)  then at 2100 it clears and revs out fine. When I take my foot off the gas it drops right down and dies. after a few minutes wait it starts again. it's like this hot or cold.

I did find the pipe from the fuel regulator to idle housing had come off but replacing it made no difference. I'm thinking fuel starvation, maybe a blocked fuel filter slowing the flow and will be getting a new one on Monday but I was hoping you lot may have a few more ideas . I only want to make 1 trip to the shop so any other things I can look at now before shopping would be great.. It started after I put fuel in from a garage with all but one pump closed, I was thinking I might have put crud from their tanks into mine.. thanks..
so many hills , so little time ....
discovery TD5
work in progress...lol

Offline andyb

  • Posts: 412
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Tilshead, Wiltshire
  • Referrals: 0
Re: disco 1 3.9 V8 help needed..
« Reply #1 on: March 20, 2012, 15:26:11 »
If it was fuel starvation then it would struggle to maintain high rpm, or would accelerate better on smaller throttle openings.

I would look at the throttle position sensor and/or the air flow meter.

Offline lee celtic

  • Regional Rep
  • *
  • Posts: 2680
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: disco 1 3.9 V8 help needed..
« Reply #2 on: March 20, 2012, 22:04:54 »
changed the filter and it was restricted compared with the new one, It made it better but it still chugs through the 1800- 2100 rev range.. I had a quick look at the air flow meter and it looks dirty inside. two questions then.. would this cause the struggle to get through the revs and if so how do I clean it?? (ie. what with) 

Thanks for the reply Andy..
so many hills , so little time ....
discovery TD5
work in progress...lol

Offline Dr Neil

  • Posts: 818
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Referrals: 0
Re: disco 1 3.9 V8 help needed..
« Reply #3 on: March 20, 2012, 22:34:39 »
you shud be o.k to use brake cleaner.
200tdi over 200kmiles
+2"lift.
Procomp Es9000 shocks
235 MT's on silver modulars
diff guards
tank guard
Paidia4x4 winch bumper.
Discoparts HD rear bumper.
Champion 10000N winch
CB and CDplayer
Safari snorkel
modified turbo actuator vac pipe pick up.
twin batteries with Paidia4x4 split charge system
roof lightbar

Offline ukmudmaster

  • Posts: 293
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
    • Billericay Essex
  • Referrals: 0
Re: disco 1 3.9 V8 help needed..
« Reply #4 on: March 21, 2012, 20:42:18 »
My RRC did this the air flow meter was U/S, try WD40 on the plug/socket first though, a bit of damp in there causes grief,
Dave
Range Rover Classic EFI auto, 3.9 V8 Offroader, 300 Tdi Auto greenlaner.
axledeep@googlemail.com

Offline lee celtic

  • Regional Rep
  • *
  • Posts: 2680
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: disco 1 3.9 V8 help needed..
« Reply #5 on: March 23, 2012, 15:06:10 »
Thanks guys... I'm going to give all the plugs a going over this weekend.. I also had a chat with a RAC patrol guy who used to work for the local landrover place.. He said to check for a worn spot on the throttle position thingy and clean the maf so it looks like that could be it.. I let you know..lol
so many hills , so little time ....
discovery TD5
work in progress...lol

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal